What is Distributedcom error 10010?

Ahmir
Comments Off on What is Distributedcom error 10010?
November 5, 2022

Cause : This event is logged when the server did not register with DCOM within the required time-out period. An error condition may have resulted from a problem in the application’s code. Report the event message to the application developer so that the developer can debug and fix the application.

10010 : Source: Microsoft-Windows- DistributedCOM : Description: The server %1 did not register with DCOM within the required time-out period. Event Information: According to Microsoft : Cause : This event is logged when the server did not register with DCOM within the required time-out period. Resolution : Report the error to the application developer

Updated April 2024: Stop error messages and fix your computer problem with this tool. Get it now at this link

Download and install the software.
It will scan your computer for problems.
The tool will then fix the issues that were found.

Table of Contents

How do I fix DistributedCOM error 10010?

Go to Run and type DCOMCNFG, Computer > My Boot Computer > Sesclu.
Click on the “Security” tab.
Click User Permissions, click Edit, then click OK. User-defined read and write accesses are logged.
Restart your machine normally.

How do you fix a DistributedCOM warning?

Default access permission.
Permission to run by default.
Restriction of access to the car.
Restriction of starting the car.

How do I stop DistributedCOM errors?

Click the Default Properties tab. Click “Enable Distributed COM” in this computer scan package to select (or remove). If you want to set additional properties for the computer, click Apply to enable (or disable) DCOM. Otherwise, click OK to exit Teams and resume Dcomcnfg.exe.

What causes a DCOM error?

A DCOM error usually occurs whenever an application or service tries to use DCOM but may not have the correct permissions. In most cases, DCOM errors do not affect other systems, but do clog some event viewers.

Sometimes, after updating the Windows operating system, the following message may appear in the system logs in Event Viewer: Error Event ID 10010. Error – The server did not register with DCOM in the allotted time. What does the above DCOM error message mean and how can you fix this error?

Updated: April 2024

Are you grappling with persistent PC problems? We have a solution for you. Introducing our all-in-one Windows utility software designed to diagnose and address various computer issues. This software not only helps you rectify existing problems but also safeguards your system from potential threats such as malware and hardware failures, while significantly enhancing the overall performance of your device.

Step 1 : Install PC Repair & Optimizer Tool (Windows 10, 8, 7, XP, Vista).
Step 2 : Click Start Scan to find out what issues are causing PC problems.
Step 3 : Click on Repair All to correct all issues.

Event ID – 10010 Site %1 did not register DCOM within the required timeout. This event is logged when a remote computer does not register with DCOM within the required timeout. The misdiagnosis may be due to a real problem in the application code.

According to them, you get distributed errors with different event IDs. Usually these events can be safely ignored as they do not affect functionality and are trending. However, you can try the steps below and see if the experts say they help. Perform a clean boot on the PC and see if they all get the same event IDs.

How do I fix Distributedcom error 10010?

This is from the Symantec website: go to the Run and Simulate section. Run DCOMCNFG, Computer > My Computer > Sesclu. Click on the “Security” tab. Click User Permissions, click Edit, then click OK. User access rights are retained. Restart this machine.